American Standard Taper Pipe..........................................................NPTF
British Association......................................BA
British Standard Fine..........................................................BSF
British Standard Pipe...........................................................BSP
British Standard Whitworth.................................................Whit.
Metric........................................................Met.
Metric Taper Pipe (seeBritish).......................BSP
Unified Course............................................UNC
Unified Fine............................................................UNF
CASE SCREWS (250/350NC)
6mm x 1.0 tpi Allen cap screw;
use 5mm Allen wrench/socket.
6x15 x19
6x25 x11
6x35 x5
6x40 x7
6x50 x5
Cylinderhead = 6x15 x17
Timing Cover = 6x25 x3
= 6x40 x1
= 6x50 x1
= Special x2
Gear Change = 6x25 x3
= 6x35 x2
= 6x40 x1
Primary Cover = 6x40 x5
= 6x50 x3
Clutch Cover = 6x15 x2
Bevel Tower = 6x35 x2
Lower Bevel = 6x15 x2
Main Case = 6x25 x5
= 6x35 x1
Metric wrench set.............................................7mm - 19mm
American wrench set.....................1/4” - 3/4”
Adjustable wrench (Crescent)..........6” & 12”
Metric sockets, 3/8” drive...........10mm - 19mm
Metric socket, each, 1/2” drive.......... .....30mm
American sockets, 3/8” drive...........3/8” - 3/4”
American socket, 1/2” drive, 6 pt.....3/4”- 15/16”
Metric allen wrench & 3/8” driver set.....5-14mm
Screw driver set, straight & Phillips............misc.
3/8” Ratchet, medium
3/8” drive Extension, straight 4”.
3/8” drive Extension w/wobbly end, 8” & 12” lg.
3/8” drive Extension, straight 12”.
3/8” drive T-handle.
3/8” drive breaker bar.
3/8” to 1/2” and 1/2” to 3/8” adapters.
1/2” drive Extension, straight 6”.
1/2” drive breaker bar.
1/2” drive Torque wrench (clicker type).
1/2” drive air gun.
3/8” drive Butterfly gun.
Punch & chisel set.
Rubber Hammer.
Ballpien Hammer.
Needle Nose.
Wire Cutters.
Safety wire pliers.
Snap-ring pliers.
Flat jaw pliers.
Channel-lock pliers.
Vice-grips, small & med.
File set.
Drill set (good quality).
Drill motor, 1/2” chuck, and variable speed.
Hack saw, with selection of blades.
Straight edge.
Square & rulers.
Fine tipped ink markers, selection of colors.
Compressed air (compressor).
Cleaning tank (solvent) & brushes.
Ducati Flywheel/Mag puller (2 types, narrow & wide-case).
Ducati Manual, this one.
Tuning For Speed, by Phil Irving.
Stocked refrigerator!
